Santa Rosa Cartunes

Where Every Listening Experience Becomes An Emotional Experience

helix P TWO
2-channel high-res amplifier with integrated, active crossover and digital signal input
$1200

 
 

HELIX P TWO

Power and sensitivity in abundance - the new P TWO combines two features in a unique way. With a continuous output power of 2 x 490 watts at 2 ohms, this compact amplifier is able to get even powerful subwoofers up to speed. The technical design is virtually predestined for all woofers with a 2 x 2 ohm double voice coil, such as the new HELIX Q subwoofers.

But despite its sheer power, the P TWO is by no means a pure subwoofer amplifier. On the contrary - their Ultra HD Class D technology enables an extended audio frequency response of over 40 kHz, paired with a high damping factor, minimal distortion and an excellent signal-to-noise ratio. This makes the P TWO the ideal playing partner for heavy-duty front systems in audiophile system configurations.

features

  • "Ultra HD Class D" concept, which combines the sound quality of Class AB technology with the advantages of a Class D amplifier

  • Two speaker outputs, each with 490 watts RMS at 2 ohms

  • Digital, optical signal input in SPDIF format including SPDIF Direct In switch to route the digital input signal directly to the power amplifier

  • The latest generation of BurrBrown DA converters with 32-bit resolution

  • Integrated, active crossover with high-pass, low-pass, band-pass and configurable bass boost

  • Intelligent high level input with ADEP circuit

  • Wired remote control for volume control

  • Extremely compact dimensions and low heat generation thanks to very high efficiency

  • For vehicles with 24 volt power supply

 

Special Features:

Ultra HD Class D amplifier technology

Compared to conventional Class D amplifiers, this concept achieves an extended frequency response of up to more than 40 kHz with a reduced distortion factor thanks to a sophisticated new type of negative feedback. The result: the sound quality of a Class AB amplifier combined with the efficiency of Class D concepts.

Signal converter with native 32-bit resolution

In the optical signal input, the HELIX P TWO uses a high-quality DA converter of the latest generation with a native resolution of 32 bits instead of the usual 24 bits. This results in unprecedented precision in signal conversion, which further optimizes the sound at lower signal levels. 

Intelligent high level input


Modern, factory-installed car radios are becoming more and more intelligent when it comes to diagnosing the connected loudspeakers. If an amplifier is connected to the radio instead, error messages or the omission of individual functions (such as faders) usually occur. The new ADEP (Advanced Diagnostics Error Protection) circuitry prevents all of these problems without unnecessarily loading the radio's speaker outputs at high levels.

start-stop capability


The power pack in the HELIX P TWO amplifier ensures the internal power supply even in the event of short-term dips down to 6 volts. This ensures that the HELIX P TWO remains fully functional even when the engine is started.

Top